结构海床耦合系统动力分析数值模型及考察     

刘海笑  赵强 《海洋技术学报》2007,26(3):48-51

基于改进的哈丁模型建立了结构海床耦合系统的等效线性化动力分析模型。等效阻尼比是对土体进行等效线性化分析的重要组成,论文着重对土体阻尼对结构海床耦合系统的影响效应进行了考察。接触面分离力是运用滑动库仑摩擦模型进行接触面效应模拟的重要参数,在以前的工作基础上,文中提出了新的结构-海床接触面分离力模型并进行了考察,使其更符合实际情况  相似文献   

A Step Towards Evaluation of the Seismic Response Reduction Factor in Multistorey Reinforced Concrete Frames   总被引：1，自引：0，他引：1  

Barakat  Samar a.  Husein Malkawi  Abdallah I.  Al-Shatnawi  Anis S. 《Natural Hazards》1997,16(1):65-80

A seismic nonlinear time-history analysis was made for four-, six-, and eight-storey reinforced concrete buildings. These buildings were made as three-dimensional space frame structures with shear walls in both orthogonal directions. They have five bays with 4.8 m spacing each in the horizontal direction, and three bays with 4.2 m spacing each in the transversal direction. The frames were designed according to the Jordanian Seismic Code of practice for Seismic Zones 4, 3, 2, and 1 as proposed for Jordan by several authors. Time-history analysis was made using the El Centro (N-S) earthquake record of May 1940 as an actual earthquake excitation. The response reduction factor (R) that primarily consists of two factors that are the ductility reduction (Rµ) and the overstrength (), is obtained. It has been seen that the seismic zoning has a slight effect on the ductility reduction factor for different buildings, since it ranges from Zone 4 to Zone 1 as 2.37 to 2.52, 1.72 to 1.78, and 1.14 to 1.18 for four-, six-, and eight-storey buildings, respectively. Moreover, it is observed that, for different buildings and different seismic zones, the ductility reduction factor (Rµ) is slightly different from the system ductility factor (µ) especially for higher values of µ (i.e., Rµ µ). The response reduction factor, called overstrength (), was evaluated. The overstrength factor was found to vary with seismic zones (Z) , number of stories, and design gravity loads. However, the dependency on seismic zones was the strongest. The average overstrength of these buildings in Zones 4 and 1 was 2.61 and 6.94, respectively. The overstrength increased as the number of storeys decreased: overstrength of a four-storey building was higher than an eight-storey building by 36% in Zone 4, and 39% in Zone 1. Furthermore, buildings of the three heights had an average overstrength 165.9% higher in Zone 1 than in Zone 4. These observations have a significant implications for the seismic design codes which currently do not take into account the variation of the response reduction factor, R (i.e., ductility reduction factor times overstrength).  相似文献   

T形短肢剪力墙静力性能有限元仿真分析   总被引：4，自引：0，他引：4  

王建祥  苏枋  胡景龙  李青宁  于建军 《工程地质学报》2006,14(5):703-708

利用有限元分析软件ANSYS,首先采用其中三维实体单元SOLID65建立了T形短肢剪力墙有限元分析模型,从弹性到混凝土开裂直至破坏的全过程进行了仿真试验分析。分析了影响短肢剪力墙受力的几种因素:混凝土强度等级、配筋率、轴压比、墙肢截面高厚比对短肢剪力墙承载能力、变形能力及延性的影响,剖析了短肢剪力墙破坏过程及其原因。比较真实的反映了短肢剪力墙在轴压力和逐步加载侧向力共同作用下的响应。试验结果表明:增加混凝土等级和轴压比能提高试件的开裂、屈服和极限荷载,但应综合考虑其与变形能力、延性的关系。截面配筋率具有其特殊性,配筋率在1.4%1.6%之间时试件的承载能力、变形能力及延性较好。墙肢截面高厚比是不稳定因素但在高厚比为6.57.1时,延性及变形能力较强。  相似文献   

Tests on low‐ductility RC frames under high‐ and low‐frequency excitations     

Ser‐Tong Quek  Chengmei Bian  Xilin Lu  Wensheng Lu  Haibei Xiong 《地震工程与结构动力学》2002,31(2):459-474

The response of low‐ductility reinforced concrete (RC) frames, designed typically for a non‐seismic region, subjected to two frequencies of base excitations is studied. Five half‐scaled, two‐bay, two‐storey, RC frames, each approximately 5 m wide by 3.3 m high, were subjected to both horizontal and/or vertical base excitations with a frequency of 40 Hz as well as a lower frequency of about 4 Hz (close to the fundamental frequency) using a shake table. The imposed acceleration amplitude ranged from 0.2 to 1.2g. The test results showed that the response characteristics of the structures differed under high‐ and low‐frequency excitations. The frames were able to sustain high‐frequency excitations without damage but were inadequate for low‐frequency excitations, even though the frames exhibited some ductility. Linear‐elastic time‐history analysis can predict reasonably well the structural response under high‐frequency excitations. As the frames were not designed for seismic loads, the reinforcement detailing may not have been adequate, based on the crack pattern observed. The effect of vertical excitation can cause significant additional forces in the columns and moment reversals in the beams. The ‘strong‐column, weak‐beam’ approach for lateral load RC frame design is supported by experimental observations. Copyright © 2001 John Wiley & Sons, Ltd.  相似文献   

Decoupled seismic analysis of an earth dam   总被引：2，自引：0，他引：2  

Ernesto Cascone  Sebastiano Rampello 《Soil Dynamics and Earthquake Engineering》2003,23(5):349-365

The seismic stability of an earth dam is evaluated via the decoupled displacement analysis using the accelerograms obtained by ground response analysis to compute the earthquake-induced displacements. The response analysis of the dam is carried out under both 1D and 2D conditions, incorporating the non-linear soil behaviour through the equivalent linear method. Ten artificial and five real accelerograms were used as input motions and four different depths were assumed for the bedrock.1D and 2D response analyses were in a fair agreement with the exception of the top third of the dam where only a 2D modelling of the problem could ensure that the acceleration field is properly described. The acceleration amplification ratio obtained in the 2D analyses was equal to about 2 in all the cases considered, consistently with data from real case histories.The maximum permanent displacements computed by the sliding block analysis were small, being less than 10% of the service freeboard; a satisfactory performance of the dam can then be envisaged for any of the seismic scenarios considered in the analyses.  相似文献   

A procedure for evaluating seismic energy demand of framed structures     

Chung‐Che Chou  Chia‐Ming Uang 《地震工程与结构动力学》2003,32(2):229-244

Energy serves as an alternative index to response quantities like force or displacement to include the duration‐related seismic damage effect. A procedure to evaluate the absorbed energy in a multistorey frame from energy spectra was developed. For low‐ to medium‐rise frames, it required a static pushover analysis of the structure to determine the modal yield force and ductility factor of an equivalent single‐degree‐of‐freedom system for the first two modes. The energy spectra were then used to determine the energy contribution of each mode. A procedure was also developed to distribute the energy along the frame height based on energy shapes. This study showed that the second‐mode response in some cases needs to be considered to reflect the energy (or damage) concentration in the upper floors. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

对目前岩石“全曲线”测试的若干看法   总被引：1，自引：0，他引：1  

马世民  马宇博 《岩土力学》2003,(Z1)

从电液伺服岩石压力试验机工作机理的角度,对目前岩石应力-应变全过程曲线(以下简称“全曲线”)测试中的一些问题进行了分析,提出了自己的看法,目的是为了解决“全曲线”测试的2个问题,即如何测出“全曲线”;如何使测出的“全曲线”真实反映岩石的力学特性,并将其用到工程中。  相似文献   

重磁遗传算法三维反演中高速计算及有效存储方法技术   总被引：13，自引：15，他引：13       下载免费PDF全文

姚长利  郝天珧  管志宁  张聿文 《地球物理学报》2003,46(2):252-258

将地下场源区域规则划分成很多小长方体单元，并且通过反演确定这些单元的物性变 化，勾画出场源的分布图像，这种方式逐步成为重磁反演，特别是三维反演的重要方向；遗 传算法等非线性技术进行该类反演将逐步成为发展趋势. 本文指出，在应用遗传算法进行该 类反演过程中，隐含着数据量较大时超常规的计算量，它已成为制约该类反演充分发挥作用 的瓶颈问题；同时，本文提出了针对性的分离并存储几何格架的计算策略、以及独特的几何 格架等效压缩存储技术，可以从根本上提高非线性反演计算速度，为该类反演的有效应用奠 定了坚实的基础.  相似文献   

A　Comparative　Study　of　the　Atmospheric　Layers　below　First　Lifting　Condensation　Level　for　Instantaneous　Pre-Monsoon　Thunderstorm　Ocurence　at　Agartala(23°30′N,91°15′E)　and　Ranchi(23°14′N,85°14′E)　of　India     

Sarbari Ghosh  Utpal Kumar De Atmospheric Science Research  Department of Physics  Jadavpur University  Calcutta  India Received April    revised July   《大气科学进展》1997,(1)

ＡＣｏｍｐａｒａｔｉｖｅＳｔｕｄｙｏｆｔｈｅＡｔｍｏｓｐｈｅｒｉｃＬａｙｅｒｓｂｅｌｏｗＦｉｒｓｔＬｉｆｔｉｎｇＣｏｎｄｅｎｓａｔｉｏｎＬｅｖｅｌｆｏｒＩｎｓｔａｎｔａｎｅｏｕｓＰｒｅ－ＭｏｎｓｏｏｎＴｈｕｎｄｅｒｓｔｏｒｍＯｃｕｒｅｎｃｅａｔＡｇａ...  相似文献   

Seasonal variation of the total electron content, maximum electron density and equivalent slab thickness at a South-American station     

G.A. Mansilla  M. Mosert  R.G. Ezquer   《Journal of Atmospheric and Solar》2005,67(17-18):1687

Total electron content (TEC) and foF2 ionosonde data obtained at Tucumán (26.9°S; 65.4°W) from April 1982 to March 1983 (high solar activity period) are analyzed to show the seasonal variation of TEC, NmF2 (proportional to square of foF2) and the equivalent slab thickness EST. Bimonthly averages of the monthly median for January–February, April–May, July–August and October–November have been considered to represent summer, autumn, winter and spring seasons, respectively. The results show that the higher values of TEC and maximum electron density of F2-layer NmF2 are observed during the equinoxes (semiannual anomaly). During daytime, both in TEC and in NmF2 the seasonal or winter anomaly can be seen. At nighttime, this effect is not observed. Also, the observed NmF2 values are used to check the validity of International Reference Ionosphere (IRI) to predict the seasonal variability of this parameter. In general, it is found that averaged monthly medians (obtained with the IRI model) overestimate averaged monthly median data for some hours of the day and underestimate for the other hours.  相似文献